Llawlyfr Defnyddiwr Modiwl Rhyngwyneb Plygiadwy Cellog Cisco PIM

Cisco PIM Cellular Pluggable Interface Module User Manual

cisco-logo

Modiwl Rhyngwyneb Plygiadwy Cellog Cisco PIM

Cisco-PIM-Cellular -Pluggable-Interface-Module-product

Manylebau

  • Yn cefnogi galluoedd cloi a datgloi SIM
  • Cymorth SIM deuol at ddibenion copi wrth gefn
  • Actifadu SIM awtomatig ar gyfer cadarnwedd priodol
  • Dewis Rhwydwaith Symudol Tir Cyhoeddus (PLMN)
  • Cefnogaeth rhwydwaith LTE preifat a 5G preifat
  • Dau PDN pro gweithredolfiles ar ryngwyneb Cellog
  • Cefnogaeth ar gyfer traffig data IPv6
  • Nodweddion gwasanaethadwyedd cellog ar Cisco IOS-XE

Rhagofynion ar gyfer Ffurfweddu PIM Cellog

Nodyn

You must have the appropriate antennas and antenna accessories to complete your installation. Consult the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for suggestions on possible solutions.

  • If the signal is not good at the router, place the antenna away from router in a better coverage area. Please refer to the RSSI/SNR values as displayed through show cellular <x/x/x> all or the LED of the pluggable modem.
  • You must have cellular network coverage where your router is physically placed. For a complete list of supported carriers.
  • You must subscribe to a service plan with a wireless service provider and obtain a Subscriber Identity Module (SIM) card. Only micro SIMs are supported.
  • You must install the SIM card before configuring the Cellular PIM or router.
  • The standalone antenna that supports GPS capabilities must be installed for the GPS feature to work when available on the PIM.

Cyfyngiadau ar gyfer Ffurfweddu PIM Cellog

  • Currently, cellular networks support only user initiated bearer establishment.
  • Due to the shared nature of wireless communications, the experienced throughput varies depending on the radio network capabilities, number of active users or congestion in a given network.
  • Cellular bandwidth is asymmetric with the downlink data rate being greater than the uplink data rate, while on private cellular with TDD frequency band(s), it may be symmetrical.
  • Cellular networks have higher latency compared to wired networks. Radio latency rates depend on the technology and carrier. Latency also depends on the signal conditions and can be higher because ofnetwork congestion.
  • CDMA-EVDO, CDMA-1xRTT, and GPRS technology modes are not supported. 2G is only supported on the P-LTE-GB.
  • Any restrictions that are part of the terms of service from your carrier.
  • SMS—Only one text message up to 160 characters to one recipient at a time is supported. Larger texts are automatically truncated to the proper size before being sent.

Nodweddion Heb eu Cefnogi

The following features are not supported:

  • On Cisco IOS-XE, TTY support or Line is not available on cellular interface as it was on IOS classic.
  • On Cisco IOS-XE, explicit Chat script /Dialer string doesn’t need to be configured for the cellular interface as it was on IOS classic.
  • DM log output to USB flash is not supported
  • Gwasanaethau llais

Prif Nodweddion PIM Cellog

The PIM supports the following major features:

Nodwedd Disgrifiad
SIM lock and unlock capabilities Cefnogir cerdyn SIM gyda mecanwaith diogelwch sy'n gofyn am god PIN, gweler Cardiau SIM ar y Modiwl Rhyngwyneb Plygiadwy Cellog (PIM) am fanylion.
Nodwedd Disgrifiad
SIM deuol

Nodyn

Not supported on the P-LTE-VZ pluggable

For backup purpose, a cellular PIM may support two SIM cards, enabling auto-switch failover between primary and backup (backup only) mobile carrier’ services from a single Cellular PIM, see SIM Cards on the Cellular Pluggable Interface Module (PIM) am fanylion.
SIM Awtomatig Cisco IOS-XE feature enabling a Cellular PIM to activate the appropriate firmware associated to a SIM card from a mobile carrier, see SIM Cards on the Cellular Pluggable Interface Module (PIM) am fanylion.
Dewis Rhwydwaith Symudol Tir Cyhoeddus (PLMN) By default, a Cellular PIM will attach to its default network associated to the installed SIM card. In case of private Cellular network or to avoid roaming, a

cellular interface can be configured to only attach to a given PLMN. See PLMN Search and Selection am fanylion.

LTE Preifat

Nodyn

Private 4G and private 5G networks are leveraging spectrum that can be obtained by enterprises to deploy the private cellular infrastructure. It can either be a subset of SP spectrum or a frequency band dedicated to private network in countries, for example 4G band 48 (CBRS) in U.S., 5G band n78 in

yr Almaen,

Ar fodiwlau PIM Cellog priodol, er enghraifftample, P-LTEAP18-GL and P-5GS6-GL, frequency bands allowing connectivity to private LTE and/or private 5G infrastructure are supported. See Cellular Band Lock.
Dau PDN pro gweithredolfiles Ar ryngwyneb Cellog, hyd at 16 PDN profiles can be defined, while two could be active, dependent of the SIM subscription and services, see Using Data Profiles am fanylion.
IPv6 IPv6 data traffic is fully supported over Cellular network. See Configuring Cellular IPv6 Address.
Rhwydwaith Symudol IPv6

Nodyn

Not available on all mobile carriers.

Gellir ymlyniad cellog i APN ar rwydwaith symudol drwy IPv4 ac IPv6, neu IPv6 yn unig.
Gwasanaethadwyedd cellog On Cisco IOS-XE, several features such as LTE Link recovery, firmware upgrade, DM logs collection can be configured to ease the operations and offer better serviceability, see Cellular Serviceability am fanylion.
Nodwedd Disgrifiad
Gwasanaeth Neges Fer (SMS) Gwasanaeth negeseuon testun gyda negeseuon yn cael eu cyfnewid rhwng dyfais modem a chanolfan gwasanaeth SMS mewn mecanwaith storio ac anfon ymlaen.

Ar lwybrydd Cisco IOS-XE, gellir defnyddio SMS sy'n mynd allan i anfon neges anadlu marw at ddatrysiad rheoli neu weithredwyr.

SMS on dying gasp is available on some cellular PIMs such as P-LTEA-EA, P-LTEA-LA and

P-LTEAP18-GL.

Gwel Short Message Service (SMS) and Dying Gasp am fanylion

Protocol Rheoli Rhwydwaith Syml (SNMP) 3G/4G MIB Cellular WAN MIBs and Traps sending management information through SNMP to a Management solution, see Sylfaen Gwybodaeth Rheoli am fanylion
GPS

Nodyn

Gwel Supported Modem Technology for GPS support.

Global Navigation Satellite System (GNSS) (requires a GNSS compliant antenna) and National Marine

Electronics Association (NMEA) streaming.

FAQ

  • C: A allaf ddefnyddio unrhyw fath o antenâu gyda Modiwl Rhyngwyneb Plygiadwy Cellog Cisco?
    • A: No, it is recommended to use antennas and accessories specified in the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for compatibility and performance.
  • C: Faint o PDN profileGall s fod yn weithredol ar y rhyngwyneb Cellog?
    • A: Hyd at ddau PDN profiles can be active on the Cellular interface, depending on the SIM subscription and services.

Dogfennau / Adnoddau

PDF thumbnailModiwl Rhyngwyneb Plygiadwy Cellog PIM
User Manual · P-LTE-VZ, PIM Cellular Pluggable Interface Module, PIM, Cellular Pluggable Interface Module, Pluggable Interface Module, Interface Module, Module

Cyfeiriadau

Gofyn Cwestiwn

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Gofyn Cwestiwn

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.