Seiko Bell Alarm Clock QHK035C User Manual

Rhagymadrodd

This manual provides detailed instructions for the setup, operation, and maintenance of your Seiko Bell Alarm Clock, model QHK035C. Please read this manual thoroughly before using the clock to ensure proper function and longevity.

Ffigur 1: Blaen view of the Seiko Bell Alarm Clock QHK035C. The clock features a cream-colored plastic casing, a classic analog dial with large black numbers, and two bell hammers on top for the alarm function. It stands on two silver-colored feet.

Gwybodaeth Diogelwch

• Peidiwch ag amlygu'r cloc i dymheredd eithafol, golau haul uniongyrchol, na lleithder uchel.
• Osgowch ollwng y cloc neu ei rhoi dan effeithiau cryf.
• Cadwch y cloc i ffwrdd o feysydd magnetig cryf.
• Peidiwch â cheisio dadosod na thrwsio'r cloc eich hun. Cyfeiriwch at bersonél gwasanaeth cymwys.
• Gwaredwch batris ail-law yn unol â rheoliadau lleol.

Cynnwys Pecyn

Gwiriwch fod yr holl eitemau yn bresennol yn y pecyn:

• Seiko Bell Alarm Clock (Model QHK035C)
• 1 AAA Battery (pre-installed or included separately)
• Y Llawlyfr Cyfarwyddiadau hwn

Gosod

1. Gosod Batri

1. Lleolwch glawr adran y batri ar gefn y cloc.
2. Tynnwch y clawr trwy ei lithro neu ei agor yn ysgafn.
3. Insert one AAA battery, ensuring the correct polarity (+ and -) as indicated inside the compartment.
4. Amnewid y clawr adran batri yn ddiogel.

2. Gosod yr Amser

1. On the back of the clock, locate the SET AMSER bwlyn.
2. Cylchdroi y SET AMSER knob in either direction to move the hour and minute hands to the desired current time.
3. For accuracy, it is recommended to set the time slightly ahead and then turn the knob backward to the exact time.

3. Gosod y Larwm

1. Lleolwch y SET ALARM knob on the back of the clock.
2. Cylchdroi y SET ALARM knob to move the alarm hand to your desired alarm time.
3. Ensure the alarm ON/OFF switch (usually a small slide switch) on the back or side of the clock is in the ON sefyllfa i ganu'r larwm.

Cyfarwyddiadau Gweithredu

1. Swyddogaeth Larwm

• When the alarm is set and activated, it will sound at the designated time.
• To stop the alarm, slide the alarm ON/OFF switch to the ODDI AR position. The alarm will reset for the next 24 hours if the switch remains ON.

2. Swyddogaeth Snooze

• When the alarm sounds, press the large button on top of the clock (often labeled SNOOZE / GOLAU).
• The alarm will temporarily stop and sound again after approximately 5-10 minutes (duration may vary by model).
• Gallwch ailadrodd y swyddogaeth snooze sawl gwaith.
• To permanently stop the alarm, slide the alarm ON/OFF switch to the ODDI AR sefyllfa.

3. Light Function (Lumibrite)

• The clock features Lumibrite hands and markers, which absorb light and glow in the dark for a period.
• To activate a temporary backlight for better visibility in low light conditions, press the large button on top of the clock (often labeled SNOOZE / GOLAU). The light will illuminate for a few seconds.

Cynnal a chadw

1. Glanhau

• Sychwch y cloc gyda lliain meddal, sych.
• Peidiwch â defnyddio glanhawyr sgraffiniol, toddyddion na chwistrellau cemegol, gan y gall y rhain niweidio'r casing neu ddeialu.

2. Amnewid Batri

• When the clock's display dims, the alarm weakens, or the clock stops functioning, it is time to replace the battery.
• Follow the battery installation steps outlined in the Gosod adran.
• Always use a fresh AAA battery.

Datrys problemau

Manylebau

• Model: QHK035C
• Brand: Clociau Seiko
• Deunydd: Plastig
• Ffynhonnell Pwer: 1 x Batri AAA (wedi'i gynnwys)
• Nodweddion: Bell Alarm, Snooze, Lumibrite (Light)
• Dimensiynau Cynnyrch: 1.97 x 3.15 x 4.72 modfedd (5 x 8 x 12 cm)
• Pwysau: 6 owns (0.18 kg)

Gwarant a Chefnogaeth

Seiko Clocks products are manufactured to high-quality standards. For specific warranty information, please refer to the warranty card included with your purchase or visit the official Seiko Clocks website. For technical support or service inquiries, please contact Seiko customer service.