ICOM BC-152

ICOM BC-152 Charger Instruction Manual

Model: BC-152

1. Rhagymadrodd

This manual provides essential instructions for the safe and efficient operation of your ICOM BC-152 charger. Please read this manual thoroughly before using the charger to ensure proper setup, operation, and maintenance. Keep this manual for future reference.

2. Gwybodaeth Diogelwch

Always observe the following safety precautions to prevent injury, damage to the charger, or damage to the device being charged.

  • Use only with compatible ICOM battery packs. Using incompatible batteries may cause fire, explosion, or injury.
  • Peidiwch ag amlygu'r gwefrydd i law, lleithder, na thymheredd eithafol.
  • Peidiwch â dadosod na newid y gwefrydd. Cyfeiriwch bob gwasanaeth at bersonél cymwys.
  • Sicrhewch fod cyfaint yr allfa bŵertagmae e yn cyd-fynd â manylebau'r gwefrydd.
  • Cadwch y charger i ffwrdd o ffynonellau gwres a golau haul uniongyrchol.
  • Datgysylltwch y gwefrydd o'r soced pŵer pan nad yw'n cael ei ddefnyddio neu cyn glanhau.

3. Gosod

3.1 Dadbacio

Carefully remove the ICOM BC-152 charger from its packaging. Verify that all components are present:

  • ICOM BC-152 Charger Unit
  • Addasydd AC (os yw wedi'i gynnwys)
  • Llawlyfr Cyfarwyddiadau (y ddogfen hon)
ICOM BC-152 Charger Unit

Figure 1: The ICOM BC-152 charger unit. This image shows the compact black charger with a single slot for a battery pack.

3.2 Pŵer Cysylltu

  1. Connect the AC adapter cable to the DC input jack on the rear of the BC-152 charger unit.
  2. Plygiwch yr addasydd AC i mewn i allfa wal safonol.
  3. Mae'r charger bellach yn barod i'w ddefnyddio.

4. Cyfarwyddiadau Gweithredu

4.1 Charging a Battery Pack

Follow these steps to charge a compatible ICOM battery pack:

  1. Ensure the charger is connected to a power source as described in Section 3.2.
  2. Carefully insert the battery pack into the charging slot of the BC-152 charger. Ensure it is seated firmly.
  3. Observe the charging indicator light.

4.2 Goleuadau Dangosydd

The BC-152 charger features an LED indicator to show the charging status:

  • Coch (Solid): Mae'r batri yn gwefru ar hyn o bryd.
  • Gwyrdd (Solet): Charging is complete. The battery pack is fully charged.
  • Coch sy'n fflachio: Charging error or battery fault. Remove the battery and re-insert. If the error persists, consult the troubleshooting section.
  • Dim golau: Charger is not connected to power, or no battery is inserted.

Charging time may vary depending on the battery's capacity and its current charge level. Typically, a fully depleted battery will take approximately 2-4 hours to charge.

5. cynnal

5.1 Glanhau

Er mwyn cynnal perfformiad ac ymddangosiad gorau posibl:

  • Datgysylltwch y gwefrydd o'r soced pŵer bob amser cyn glanhau.
  • Defnyddiwch frethyn meddal, sych i sychu tu allan y gwefrydd.
  • Peidiwch â defnyddio glanhawyr sgraffiniol, toddyddion na chemegau llym.
  • Ensure no moisture enters the charging slot or power input.

5.2 Storio

When not in use for extended periods, store the charger in a cool, dry place, away from direct sunlight and extreme temperatures. Disconnect it from the power supply.

6. Datrys Problemau

If you encounter issues with your BC-152 charger, refer to the table below for common problems and solutions.

ProblemAchos PosiblAteb
Charger indicator light is off.No power supply or battery not inserted.Check AC adapter connection. Ensure battery is correctly inserted.
Indicator light flashes red.Battery fault or charging error.Remove and re-insert the battery. Try a different compatible battery if available.
Nid yw batri yn codi tâl.Faulty battery, charger, or power supply.Verify power connection. Test with a known good battery. If problem persists, contact support.

7. manylebau

BrandICOM
ModelBC-152
Mewnbwn Voltage12-16V DC (via AC adapter)
Allbwn Voltage8.4V DC
Codi Tâl CyfredolTua. 450mA
Dimensiynau (W×H×D)Approx. 80 × 50 × 90 mm (3.1 × 2.0 × 3.5 inches)
Pwysau0.18 pwys (tua 82g)
LliwDu

Nodyn: Mae manylebau'n destun newid heb rybudd er mwyn gwella.

8. Gwybodaeth Gwarant

ICOM products are manufactured with high-quality components and are subject to rigorous quality control. This product is covered by a limited warranty against defects in materials and workmanship. The specific terms and duration of the warranty may vary by region. Please refer to the warranty card included with your purchase or visit the official ICOM websafle am wybodaeth warant fanwl.

This warranty does not cover damage caused by misuse, accident, unauthorized modification, or improper installation.

9. Cefnogaeth i Gwsmeriaid

If you have any questions, require technical assistance, or need to report a problem that cannot be resolved using the troubleshooting guide, please contact ICOM customer support.

ICOM America Inc.
Visit ICOM America's Contact Page
Please have your product model (BC-152) and serial number ready when contacting support.

© 2023 ICOM America Inc. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.