HOLL ADNODDAU CYFRIFIADUR Modiwl Rheoli Electronig ECU
Manylebau
- Enw Cynnyrch: Electronic Control Module (ECM)
- Modiwlau â Chymorth: ECU, ECM, PCM, TCM, FICM, IDM, FCM, BCM
- Gwneuthurwr: Pob Adnodd Cyfrifiadurol
Gosodiad
Installing an ECM yourself is pretty easy. This guide lists the proper way to install an ECM when you have purchased a pre-programmed, “plug and play” ECM from All Computer Resources. Failure to fix and/or replace any bad components or connections within the vehicle can damage the new ECM and void the warranty. ECMs rarely fail on their own. Please perform any necessary repairs before installation.
Before installing ECM, make sure that
- Mae'r batri is charged at over 12V
- The wiring harness is clean and in good condition
- Any known defective parts have been replaced
- All ground connections are in good condition and tightly secured
- Darllenwch a dilynwch fwletinau TechTalk ACR001-ACR003
ECM Installation
- Datgysylltwch y derfynell negatif o'r batri
- Let the vehicle sit for thirty (30) minutes unplugged
- Install the new ECM (Be sure the connectors are inserted firmly)
- Connect ground wires back to ECM (If applicable)
- Ailgysylltu'r batri
- Turn the key to the RUN position (do not start). At this point, the “Check Engine is O, which means the ECM is working. – Leave in this position for 5 minutes
- Trowch y Ignition i'r sefyllfa OFF
- Turn the ignition ON and start car
Nodyn: Note: If you are experiencing drivability issues, please refer to Tech Talk bulletins ACR004 & ACR006. If your Check engine light stays illuminated, reset codes and follow the installation again. If the codes remain, the ECU is notifying you that there are issues with the vehicle that must be corrected.
Dychweliad Craidd: To activate the warranty and avoid a core charge, return the core within 14 days.
Cwestiynau Cyffredin
What should I do if the Check Engine light remains on after installation?
Reset the codes and repeat the installation process. If the issue persists, there may be underlying vehicle problems that need to be addressed.
How long do I have to return the core to activate the warranty?
The core must be returned within 14 days of installation to activate the warranty and avoid any core charges.
Dogfennau / Adnoddau
 |
HOLL ADNODDAU CYFRIFIADUR Modiwl Rheoli Electronig ECU [pdfCanllaw Gosod Modiwl Rheoli Electronig ECU, Modiwl Rheoli Electronig, Modiwl |